Marantz TT-15S1 User's Guide download pdf (Page 6)

The Marantz TT-15S1 comes in several pre mounted

parts, as described in Scope of supply. The set up

and installation is done quickly and very easy.

Please use the white gloves during this procedure,

to avoid scratches.

You should consider a safe and clean working area

for the installation, in spite, as near as possible to

the final position of the turntable.

First take out the accessories, the motor and the

tonearm of the packing. Now you should take out

the first packing layer. After that you can take out

the turntable chassis including the mounted lower

and upper bearing part from the second packing

layer. Place the turntable chassis on its feet on the

area where the final position of your turntable will be.

Take the motor-pulley out of the accessory bag and

shift the motor pulley as far as on the motors´ shaft

until you have a distance of approximately 1 mm

between the upper edge of the motor and the lower

edge of the pulley. Now screw the three screws in

the pulley one after the other with a screwdriver.

Lift the turntable chassis and slide the motor from

below exactly under the predefined position hole in

the chassis. Please pay attention that the switch of

the motor is outside on the left side of the record

player body. When the motor is at the right position

carefully put the chassis down again.

After that you have to centre the motor in the motor-

position hole without any contact to the turntable

chassis. This way you can use your turntable

perfectly decoupled from the motor.

Remove the second packing layer. In the bottom

packing layer you will find the turntable platter.

Please take the platter out with both hands.

Place the platter with the 60mm wide and 5mm

deep cut out on the upper bearing part. Through a

lightly up and down movement the platter will slip

onto the bearing upper part. Ensure with a gently (!)

pressure that the platter is applying on the complete

surface of the bearing.

Take the threaded bolt (M6 x 8) out of your acces-

sory bag and screw it with the adequate Allen key

into the winding near the tonearm cut of the turnta-

ble chassis, so that the front of the bolt is not

facing out the inner side of the tonearm cut.

Position the enclosed counterweight on top of the

chassis in front of the cut out for the tonearm. Take

the tonearm and slide first the interconnect cable

through the hole followed by the tonearm’s shaft.

Gently push the arm down into to the hole until the

pickup lift is seated on the counterweight (see figu-

re…). Please ensure that the tonearm tube is in

parallel to the right edge of the turntable body. Now

carefully fix by turning the pick up with an Allen key

and afterwards remove the counterweight.

When the tonearm is fixed you can connect the

cartridge to the tonearm. The guideway in the

headshell simplifies the assembling. Please fix the

cartridge, with the screw and appropriate allen key,

to the tonearm when positioned at the lower treshold

(see picture). In this position the cartridge and the

arm will automatically have the correct angle and

an optimised incline.

Carefully connect the cartridge to the tonearm cable.

The headshell wires (cartridge connection leads)

are colour coded according to the international

standard and are given in the below overview:

INSTALLATION AND SET UP

1mm

1 2 3 4 5 6 7 8 9 10 11 ... 38 39

Comments to this Manuals

No comments

Marantz TT-15S1 User's Guide Page 6

Comments to this Manuals

Related products and manuals for Audio turntables Marantz TT-15S1