Marantz SR8400 User Manual download pdf (Page 42)

ENGLISH

• If the copying fails in the middle of the

copying process, ERROR is displayed on

the remote control.

Check and perform steps 1 to 7 again.

11.

Once copying is completed, press the M

button on both remote controls.

SETUP

SETTING THE LIGHTING TIME

• The LCD lights up when the LIGHT buttons are

pressed. The LCD remains lit while the pressed

button is held down, and it goes off when the

button is released.

• The LCD continues to light up if another button

is pressed while it is lit or if pressed within two

seconds after the light goes off.

• The lighting time can be set in one-second units

from 0 to 60 seconds.

The LIGHT buttons have light-absorbing

properties that enable them to store light. If the

buttons are no longer illuminated in a dimly lit

environment, bring the buttons near a fluorescent

lamp or other light source for a sufficient amount of

time. This should illuminate the buttons again.

• The LIGHT buttons consist of a LIGHT1 and

LIGHT2 button, and they both perform the same

operation.

The factory default lighting time is set to 15

seconds.

This example shows how to set the lighting time to

20 seconds.

Hold down the M button for three seconds or

more.

The menu is displayed.

Press the > button to display the second page

SETUP menu.

Press the D1 (LIGHT) direct button .

The LIGHT is displayed on the LCD

Press the or cursor button to set the

lighting time.

Press the OK cursor button to enter the

lighting time.

Once the setting is finished, press the M

button .

SETTING THE MACRO INTERVAL TIME

When a macro program is executed, control

signals are transmitted in sequence. This

transmission interval (interval time) can be set in

0.5-seconds units from 0.5 to 5 seconds.

If the interval time is set in this Setup mode, the

interval times for all programmed macros are

changed. If necessary, use EDIT (see page 37) in

the macro program to change the individual

transmission times.

The factory default setting for the transmission

interval is 1 second.

This example shows how to set the interval time to

5 seconds.

Hold down the M button for three seconds or

more.

The menu is displayed.

Press the > button to display the second page

SETUP menu.

Press the D2 (I-TIME) direct button .

Press the or cursor button to set the

interval time.

Holding down the cursor button fast-forwards the

time indicator.

Press the OK cursor button to enter the

interval time.

Once the setting is finished, press the M

button .

ADJUSTING THE DISPLAY CONTRAST

The contrast of the LCD can be adjusted. Adjust

for maximum visibility according to your viewing

environment.

Hold down the M button for three seconds or

more.

The menu is displayed.

2 .

Press the > button to display the second page

SETUP menu.

Press the D3 (CONT) direct button .

Press the or cursor button and set the

display contrast for maximum visibility.

The adjustment has 10 levels.

The factory default setting for the contrast is the

fifth level.

Press the OK cursor button to enter the

display contrast.

Once the setting is finished, press the M

button .

PAG E

23 4

LEARN

123

LEARN

123

PAG E

23 4

LEARN

123

LEARN

123

PAG E

23 4

LEARN

123

LEARN

123

SR8400U DFU_01_ENG 2_2 04.1.7, 11:50 AMPage 39 Adobe PageMaker 6.5J/PPC

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 51 52

Comments to this Manuals

No comments

Marantz SR8400 User Manual Page 42

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Marantz SR8400