Marantz PM6005 Owner's Manual download pdf (Page 31)

Appendix

TipsPlaybackConnections

Contents

Front panel Rear panel IndexRemote

Settings

When three of these units are used in the same location, each unit can be

controlled independently by setting separate remote control codes.

Be sure to check the operation of each unit after setting the remote

control codes.

The default setting is “AMP1”.

ENTER

REMOTE MODE

1 – 3

Setting remote control codes for the

remote control

2 To set the remote control codes to AMP2

Press and hold REMOTE MODE CD and number button

2 for 5 seconds or longer.

2 To set the remote control codes to AMP3

Press and hold REMOTE MODE CD and number button

3 for 5 seconds or longer.

NOTE

• To restore the remote control code default setting, press and hold REMOTE MODE

CD and number button 1 for 5 seconds or longer.

• The remote control codes returns to the default settings when the batteries are

removed. Set the remote control codes again after replacing the batteries.

Setting remote control codes

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 43 44

No comments

Marantz PM6005 Owner's Manual Page 31