Marantz CR601 User's Guide download pdf (Page 32)

ENGLISH

Symptom Cause Measures Page

The RDS (Radio Data

System) doesn’t seem

to work?

CD playback skips?

Noise is generated.

Can’t play a CD?

It takes a long time to

read CD/MP3.

It takes a long time to

locate certain tracks.

The clock is wrong?

No sound is output

when a timed playback

or recording task starts?

Standby indicator

ﬂashes.

• The current FM station does

not support RDS.

• The signal strength is poor, or

there’s too much interference.

• The CR601 is subject to

vibration.

• The disc is dirty.

• The disc is very scratched.

• DTS CD is being replayed.

• The disc is upside down.

• The disc is dirty.

• Condensation has formed

inside the CR601.

• The CD-R/RW disc is

nonstandard.

• It may take a longer time to

read CD/MP3 with many track

numbers.

• The disc is dirty.

• The disc is very scratched.

• CT (Clock Time) information

has been taken from a radio

station in another time zone.

• While a timed recording task is

in progress, the output of the

CR601 is muted.

• For timed playback, the

volume is determined by the

VOLUME control.

• The protection circuit may be

activated.

• Tune into a station that

supports RDS.

• Install an outdoor FM antenna,

change the position or

direction of your outdoor FM

antenna, and keep it away

from ﬂuorescent lights.

• Install the CR601 somewhere

free of vibration.

• Remove the disc and clean it.

• Buy a new disc.

• Do not replay DTS CD, which

is not supported by the CR601.

• Load the disc with the label-

side facing up.

• Remove the disc and clean it.

• Remove the disc and leave the

CR601 turned on for several

hours until the condensation

has evaporated.

• See “Disc Notes”.

• This is not a malfunction.

• Remove the disc and clean it.

• Buy a new disc.

• Set the clock by Manual

operation.

•

To hear what’s being recorded,

press the

MUTE button

cancel the Mute function. Press

it again to mute the CR601.

• Set the volume to a suitable

level.

• Make sure not to short-circuit

the positive and negative

speaker wires.

Abnormal Behavior:

The CR601 contains a microcomputer for signal processing and control functions. In very rare situations,

severe interference, noise from an external source, or static electricity may cause it to lockup. In the

unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five

seconds, and then plug it back in again.

CR601N_01 Eng 05.10.21 1:22 PM ページ28

1 2 ... 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments

Marantz CR601 User's Guide Page 32

Comments to this Manuals

Related products and manuals for Receiver Marantz CR601