Marantz RC1200 User Manual download pdf (Page 21)

20

ENGLISH

ON

OFF

ON / OFF

SOURCE

MACRO

MODE

LEARNING REMOTE

CONTROL RC

1200

POWER

To go ahead with the clearing operation,

release the buttons, and press the OK

Cursor button ⁄0.

Once the data is cleared, the codes are

either returned to their original display or

left empty. LCD is similarly returned to its

factory preset or left empty. All the macro

programs are also cleared.

• To cancel the memory clearing

operation, do not press the OK Cursor

button ⁄0 and simply touch any other

button.

After the OK Cursor button ⁄0 is pressed,

clearing the entire memory will take

approximately 10 seconds.

PROGRAMMING MACROS

Macros make it possible to use a single

function button to perform more complex

series of operations that would normally

require pressing several buttons. A single

button can be programmed to perform up to

10 steps in sequence. A typical example of

such a series might be as follows:

• Turn the main amplifier power ON → Switch

the function to DVD → Set the Surround

Mode to Pro Logic → Switch the TV to video

input → Set the DVD player to PLAY.

• No signals may be transmitted during

macro programming.

• The various steps that make up a macro are

set initially to be sent one after another in 1

second intervals, however these intervals

may be shortened to as little as 0.5 seconds

or lengthened to as much as 5 seconds

using the Setup mode.

• In the macro mode, the number of steps the

macro contains is displayed on LCD c.

Macros may be programmed for each of the

11 function buttons, from LD to AMP.

1. Use a ballpoint pen or other sharp point to

press the MACRO button x until the

MACRO and LEARN indicators are

displayed blinking on the LCD.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 46 47

Comments to this Manuals

No comments