Marantz DV4100 User's Guide download pdf (Page 18)

18 PREPARATION

ENGLISH

Connecting to an amplifier equipped with Dolby

Surround™

Dolby Surround sound

1 Connect the player to the TV, then connect the player’s audio Left

and Right out jacks to the corresponding in jacks on the Dolby

Surround™ Audio/Video receiver, using the audio/video cable

supplied

(C)

If your amplifier is equipped with a Dolby Digital™ decoder,

● Connect the player as described in ‘Connecting to an A/V receiver

with multi-channel decoder’.

If your TV is equipped with a Dolby Surround™ decoder,

● Connect

the player to the TV as described in ‘Connecting to a TV’.

Connecting the power cord

1 Plug the female end of the supplied power cord into the Mains (AC) jack

on the rear of the player.

2 Connect the other end of the cord to an AC outlet.

Note:

When the player is in the “STANDBY” mode, it is still

consuming some power. If you wish to disconnect your player

completely from the power, unplug the power cord from the AC

outlet.

Caution: Only qualified service personnel should remove the cover

or attempt to service this device.

Remote control battery installation

Loading the batteries

1 Open the battery compartment cover.

2 Insert batteries as indicated inside the battery compartment.

3 Close the cover.

Caution: Do not mix old and new batteries. Never mix

different types of batteries (standard, alkaline, etc.)

NTSC/PAL Settings

You can switch the NTSC/PAL setting of the DVD player to match

the video signal of your TV. This setting only affects the television’s

on-screen display that shows the stop and setup modes. You may

select either NTSC or PAL. To change the DVD player setting to

PAL or NTSC, follow the steps below.

1 Unplug the DVD player from the mains.

2 Press and hold 9 and T on the front of the DVD player. While

holding 9 and T, plug in the mains.

3 After PAL or NTSC appears on the display panel of the DVD

player, release 9 and T at the same time. The PAL or NTSC

that appears on the display panel indicates the current setting.

4 To change the setting, press T within three seconds. The new

setting (PAL or NTSC) will appear on the display panel.

MODEL

AUDIO OUT

VIDEO OUT

DIGITAL OUT

S1C

OPTICAL COAXIAL R L VIDEO

Downloaded from www.Manualslib.com manuals search engine

Downloaded From DvDPlayer-Manual.com Marantz Manuals

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 70 71

Comments to this Manuals

No comments

Marantz DV4100 User's Guide Page 18

Comments to this Manuals

Related products and manuals for DVD players Marantz DV4100