Marantz RX9001 User's Guide download pdf (Page 15)

ENGLISH

RX9001 User Guide

Support

Troubleshooting

What Do the LEDs Indicate?

Ethernet LED

Busy

The Extender’s IP address is being determined.

Green blinking

The Extender is busy processing a code or short

macro from a Control Panel.

The Extender is functioning normally.

Green

The Extender is busy processing a long macro

from a Control Panel.

Red/green blinking

The Extender is in configuration.

Refer to the topic

‘There is an IP conflict’

page 12

Red

Refer to the topic

‘There are duplicate Extender

IDs’

page 13

Refer to the Refer to the topic

‘The IP address

cannot be determined’

page 12

Red blinking

The Extender is starting up. Wait until startup has

finished.

There is an IP conflict

There is another A/V component in the network that is using the same fixed IP address as the

Extender. Change the IP address of the Extender in the Configuration Tool.

If the problem persists, check the router settings.

The IP address cannot be determined

• When using the Extender: make sure that the Extender is connected to the router with a straight

Ethernet cable.

• When configuring the Extender: make sure the PC is not using a fixed IP address but is using

DHCP instead.

• Make sure the router is switched on. If the router is using DHCP, the Extender’s IP address cannot

be determined. Make sure to use the correct network settings on the router.

Finding the Exact Location of an A/V component’s IR Receiver

1 Remove the protective tape of the Dual IR emitters.

2 Set the Dual IR emitters to the minimal power level, and hold the adhesive side of one

of the emitters 0.4 - 0.8 inch / 1 - 2 cm in front of the A/V component.

3 Make sure the Control Panel is configured to operate correctly within the

RC9001 system (e.g.: configured for WiFi, not for IR).

4 Move the emitter across the front panel of the A/V component, and at the same time,

send commands with the Control Panel to the A/V component.

Take note of when the A/V component reacts to the IR signals of the emitter.

5 When the A/V component reacts, position the emitter in that place.

LEDs

Colors

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Comments to this Manuals

No comments

Marantz RX9001 User's Guide Page 15

Comments to this Manuals

Related products and manuals for Unknown Marantz RX9001