Marantz RX9001 User's Guide download pdf (Page 16)

RX9001 User Guide

Configuration switch: 2

Operating A/V components with the Extender

The A/V components do not respond to commands from the Extender

• Check if the Busy LED blinks green when you send a command with the Control Panel. If the Busy

LED does not blink, the Extender is not receiving commands from a Control Panel.

• Make sure that the Control Panel is configured correctly in Wizz.it Ex;

• Make sure that the Extender is configured correctly in the Configuration Tool and connected

properly to the A/V components;

• Make sure that the switches on the Extender are set correctly.

There are duplicate Extender IDs

Using the Extender ID switch, assign a unique ID to each Extender in the same Wireless

Network. Make sure the Control Panel is configured accordingly in Wizz.it Ex.

You can use up to 16 different Extenders in the same Wireless Network.

Resetting the Extender

This is only necessary when the Extender shows unusual behavior.

To perform a reset, unplug the power adapter from the Extender. Wait a few seconds, and plug it in

again.

Firmware Update

When an update of the Extender firmware is available, this will be announced on the Marantz

website: http://www.marantz.com

(in the Home Entertainment section of your region).

Note You can always see the current version of the firmware in the Configuration Tool.

1 Download the new version of the firmware on the PC and save it in the desired

location.

2 Unplug the Extender. You can now update it in one of the ways described below.

Updating the Extender with the Configuration Cable

1 Connect the Extender to the PC with the configuration cable (this is the crossed

Ethernet cable enclosed).

2 Make sure that the PC is switched to DHCP while the Extender is in configuration

(normally, this should already be the case).

3 Set the Configuration switch to 2 for configuration:

The Extender will restart. After start-up, the Power and Ethernet LEDs are green and the Busy

LED is red/green blinking.

4 Open the browser.

5 Type the IP address of the Extender in the address bar of the browser: 192.168.8.80.

(This is also printed on the back of the Extender.)

You may have to refresh the browser before the Configuration Tool appears.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Marantz RX9001 User's Guide Page 16