Marantz PMD510 Operations Instructions download pdf (Page 7)

e DUBBING SPEED INDICATORS

One of these indicators will light when the NORM or HIGH speed

dubbing buttons u are pressed.

f REMOTE ENABLE INDICATOR

When using an RC-5 remote control system such as the RC5PMD

accessory, this indicator will light to show which well is selected by

the system.

Note: These indicators will light Å at power on.

OPERATION

PLAYBACK

PLAYBACK ON ONE WELL (Same procedure for Well

A or Well B)

1. Set the POWER q button to ON.

2. Press the EJECT button e to open the cassette door w.

3. Insert the Cassette into the Cassette Holder w with the

exposed tape facing down, and side “A” facing you.

4. Reset the tape counter by pressing the RESET button o.

5. If the tape has been encoded with Dolby NR, set the Dolby NR

switches !2 accordingly.

6. Press the PLAY

button to play side “A” of the cassette.

7. Press the STOP ■ button r to stop playback.

CONTINUOUS PLAYBACK

1. Insert recorded cassettes into both wells.

2. Set both REVERSE MODE switches i to

mode.

3. Set the Dolby NR switches !2 according to the tapes you are

playing back.

4. Press the CONT. button y. The CONT. Indicator d will light.

5. Press one of the PLAY buttons r. Playback will start. When that

well finishes playing side B, the second well will begin playing

side A.

6. Press STOP to stop playback.

7. Press CONT. to cancel CONT. mode.

Note: During continuous playback, the signal from both wells

goes to Line Output A.

QMS (QUICK MUSIC SEARCH) (Same procedure for

Well A or Well B)

When the Well is in the play or stop mode, press the QMS button

!0 once for each program you wish to skip. The tape counter will

display this number. (Max 15)

2. Press the fast wind key (

or ) in the direction in which you

wish to search.

3. When the beginning of the correct selection is reached, the unit

will automatically enter stop mode.

Note: Wells will not auto-reverse or switch to other Wells while

searching.

RESET buttons

Pressing this button will reset the counter time to 00.00 (0 minutes,

0 seconds)

!0 QMS (QUICK MUSIC SEARCH) BUTTON

The QMS feature allows you to search in either direction for a

specific program selection. The QMS feature can skip up to 15

selections in either direction. Press the QMS button once for each

selection you wish to skip. You will see that number on the display.

Next, press the fast wind button in the direction you wish to search.

You will see the number on the display counting down as you skip

selections. The deck will automatically stop upon reaching the

desired selection.

!1 PITCH CONTROL

This control allows –15% variation in playback speed. A center

detente allows you to locate the standard speed by feeling for the

center “click”.

!2 DOLBY B/C NR SELECTOR

This switch is used to select Dolby B or C noise reduction for

recording or playback. Most commercially available cassettes

whitch display the Double-D Logo are encoded with Dolby B noise

reduction. If recording FM broadcasts with Dolby NR, switch the

MPX filter on the rear panel D to ON.

!3 REC LEVEL CONTROL

For adjusting the record input level.

!4 REC BALANCE CONTROL

Used to adjust the left-right balance of channels while recording.

!5 PHONES SELECTOR SWITCH

This switch allows you to select Well A, Well B, or a mix of both

wells (A+B) in the phones.

!6 PHONES LEVEL CONTROL

This control adjusts the volume of the headphone output.

!7 PHONES JACK

Use this jack to connect a pair of headphones with a stereo 1/4"

connector.

!8 DISPLAY

a TAPE TIME COUNTERS

These counters display the tape position for each well in Minutes

and Seconds.

Note: The display on these counters is only an approximate

indication of minutes and seconds. It is most accurate when

using 60 minute tapes.

b BARGRAPH LEVEL METERS

These meters display the signal levels for each well in stereo.

c MEMO INDICATORS

These indicators light when the MEMO button o is pressed.

d CONT. (CONTINUOUS) INDICATOR

This indicator will light up when the CONT. mode button y is

pressed.

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comments to this Manuals

No comments

Marantz PMD510 Operations Instructions Page 7

Comments to this Manuals

Related products and manuals for Cassette players Marantz PMD510