Marantz SR6005 User Manual Page 67
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
63
Basic versionSimple version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Advanced version
Manual Setup
Setting items Setting details
Distance
(Continued)
• The speakers that can be selected differ depending on the “Amp Assign”
(vpage61) and “Speaker Config.” (vpage61) settings.
• Default settings :
Front L / Front R / Center / Subwoofer / F.Height L / F.Height R :
12.0 ft (3.6 m)
Surround L / Surround R / S.Back L / S.Back R : 10.0 ft (3.0 m)
• Set the difference in the distance between the speakers to less than 20
ft (6.0 m).
NOTE
Speakers set to “None” in “Speaker Config.” (vpage61) are not displayed.
Default : The “Distance” settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select “Default” and press ENTER, the “Default Setting?”
prompt is displayed. Select either “Yes” or “No”, and press ENTER.
Channel Level
Set the volume of the test
tone to be the same when it
is output from each speaker.
Test Tone Start : Output test tone.
• Front L / F.Height L / Center / F.Height R / Front R / Surround R /
S.Back R
z
/ S.Back L
z
/ Surround L / Subwoofer : Select the speaker.
z When the “Speaker Config.” – “S.Back” setting (vpage62) is set to
“1spkr”, “S.Back” is displayed.
• –12.0dB – +12.0dB (0.0dB) : Adjust the volume.
• When o is pressed while the subwoofer volume is set to “–12 dB”, the
“Subwoofer” setting switches to “OFF”.
• When “Channel Level” is adjusted, the adjusted values are set for all the
surround modes. To adjust the channel level separately for the different
surround modes, use the operation see page 43.
• When you press TEST TONE on the remote control unit, you can enter
this setting item immediately.
NOTE
• Speakers set to “None” in the “Speaker Config.” (vpage61) settings
are not displayed.
• When a headphones jack is inserted in the PHONES jack of this unit, the
“Channel Level” is not displayed.
Default : The “Channel Level” settings are returned to the default settings.
• Yes : Reset to the defaults.
• No : Do not reset to the defaults.
When you select “Default” and press ENTER, the “Default Setting?”
prompt is displayed. Select either “Yes” or “No”, and press ENTER.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
Setting items Setting details
Crossover Frequency
Set the maximum frequency
of the bass signal output
from each channel to
the subwoofer. Set the
Crossover Frequency to
suit the bass reproduction
capability of the speaker
being used.
Crossover : Set the crossover frequency.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz
Advanced : Specify crossover frequency for each speaker.
• Front / Center / Surround / S.Back / F.Height : Select the speaker.
• 40Hz / 60Hz / 80Hz / 90Hz / 100Hz / 110Hz / 120Hz / 150Hz / 200Hz /
250Hz : Set the crossover frequency.
• “Crossover Frequency” can be set when the “Bass Setting” –
“Subwoofer Mode” (vpage62) setting is “LFE+Main”, or when you
have a speaker that is set to “Small”.
• Always set the crossover frequency to “80Hz”. When using small
speakers, however, we recommend setting the crossover frequency to
a higher frequency.
• For speakers set to “Small”, sound below the crossover frequency
is cut from the sound output. The cut bass sound is output from the
subwoofer or front speakers.
• The speakers that can be set when “Advanced” is selected differ
depending on to the “Subwoofer Mode” setting (vpage62).
• When “LFE” is selected, speakers set to “Small” at “Speaker Config.”
can be set. If the speakers are set to “Large”, “Full Band” is displayed
and the setting cannot be made.
• If set to “LFE+Main”, this setting can be made regardless of the
speaker size.
- AV Surround Receiver 1
- IMPORTANT SAFETY 3
- INSTRUCTIONS 3
- PRÉCAUTIONS D’INSTALLATION 4
- Getting started 5
- Features 6
- Accessories 6
- About this manual 6
- Cautions on handling 7
- Speakers 9
- Blu-ray Disc player and TV 10
- Power on 11
- Preparation 13
- Speaker Detection 13
- Measurement 13
- Calculation 14
- Parameter Check 15
- Error messages 15
- BD two times in a row 16
- Basic version 17
- Connections 18
- Connecting a TV 21
- Cables used for connections 22
- Supported iPod models 23
- Connecting a CD player 24
- Connecting an antenna 24
- n AM loop antenna assembly 25
- n Using the AM loop antenna 25
- Suspending on a wall 25
- Standing alone 25
- SPKR A/B 27
- Playing a CD player 28
- Playing a USB memory device 28
- n USB operation 29
- ON to turn on power to the 30
- NET/USB twice to switch 30
- ENTER, p or 1 30
- SATR twice to switch the 31
- TUNING + or TUNING – to 31
- 1, 2 and 3 32
- Tuning in radio stations 32
- n Parental Lock 33
- n SIRIUS operation 33
- n Selecting audio programs 33
- SHIFT/TOP MENU to select 34
- PRESET +, PRESET – or 34
- SEARCH/INFO 34
- STATUS while an HD Radio 34
- SURR. to select the 35
- P.DIRECT to select the 37
- SURR. to select “DOLBY 37
- Advanced version 38
- 5.1-channel connection 41
- Front A/B connection 41
- 2.1-channel connection 42
- Bi-Amp connection 42
- Set up speakers 43
- REMOTE CONTROL jacks 44
- RS-232C connector 45
- DC OUT (TRIGGER OUT) jacks 45
- Playback (Advanced operation) 46
- Sleep timer function 47
- Panel lock function 48
- Various memory functions 48
- Connection (ZONE2) 49
- Z2 to switch the remote 50
- ON to turn on the ZONE2 50
- INPUT df 50
- How to make detailed settings 51
- ENTER to register it 53
- Input Setup 54
- Auto Preset 55
- Antenna Aiming 56
- Preset Name 56
- Input Assign 56
- Playback Mode 59
- Audio/Video Adjust 60
- n Audyssey Settings 61
- Audyssey Dynamic EQ is 62
- n Manual EQ 63
- n M-DAX 63
- n Audio Delay 63
- Manual Setup 65
- MULTEQ is pressed 68
- Other settings 72
- Operating AV equipment 73
- Registering preset codes 74
- SET until indicator blinks 75
- SET and 76
- SOURCE SEL until the LEARN 76
- Operating macro function 78
- Setting the back light 79
- Information 80
- Part names and functions 81
- Rear panel 83
- Remote control unit 84
- Inserting the batteries 85
- Other information 86
- Surround 87
- Symbols in the table 89
- Explanation of terms 92
- Troubleshooting 94
- Resetting the microprocessor 96
- Specifications 97
- Blu-ray Disc Player 101
- DVD Player 101
- Satellite Receiver 101
- Television 101
- CD Player 102
- Unit : mm (in) 103
- D&M Holdings Inc 104
Related products and manuals for Receivers and Amplifiers Marantz SR6005
(15 pages)
(104 pages)
(104 pages)© 2020, manymanuals.com. All rights reserved. | 0.165 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals