Marantz SR6005 User Manual Page 9
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
5
Basic version Advanced version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Simple version
Speakers
Carefully check the left (L) and right (R)
channels and + (red) and – (black) polarities
on the speakers being connected to the
this unit, and be sure to interconnect the
channels and polarities correctly.
Connecting the speaker cables
Peel off about 0.03 ft/10 mm of sheathing from
the tip of the speaker cable, then either twist the
core wire tightly or terminate it.
NOTE
• Connect so that the speaker cable core wires
do not protrude from the speaker terminal.
The protection circuit may be activated if the
core wires touch the rear panel or if the + and –
sides touch each other (vpage89 “Protection
Circuit”).
• Never touch the speaker terminals while the
power supply is connected. Doing so could
result in electric shock.
• Use speakers with the speaker impedances
shown below.
Speaker terminals
Speaker
impedance
FRONT A 6 − 8 Ω
FRONT A + FRONT B 8 Ω
CENTER
6 − 8 Ω
SURROUND
SURR. BACK / AMP ASSIGN
FRONT B/HEIGHT
Install
1 2 3 4 5
This unit can perform 2.0/2.1 to 7.1-channel surround playback.
This page provides the speaker installation procedure for the
7.1-channel playback using surround back speakers as an example.
The default setting is 7.1-channel. You can also perform 5.1-channel playback.
To perform 5.1-channel playback, connect5.1-channel speakers only.
Use Audyssey Auto Setup function of this unit to automatically detect the
number of connected speakers and perform optimal settings for the speakers
to be used.
FL FR
C
SBL SBR
SL
SR
SW
90 – 110˚
22 – 30˚
135 – 150˚
Listening
position
FL Front speaker (L) • Install the surround speakers in a position 2 to
3 ft (60 to 90 cm) higher than ear level.
Surround back
speaker
• Point slightly
downwards
Front
speaker
Surround
speaker
2 – 3 ft /
60 – 90 cm
GViewed from the sideH
FR Front speaker (R)
C Center speaker
SW Subwoofer
SL Surround speaker (L)
SR Surround speaker (R)
SBL Surround back speaker (L)
SBR Surround back speaker (R)
1
Connect
1 2 3 4 5
2
The “Simple version” section provides the speaker installation, connection, and setup methods for the 7.1-channel system with surround back speakers.
For the installing, connecting, and setup methods of speakers other than the 7.1-channel system (with surround back speakers), see page 35.
- AV Surround Receiver 1
- IMPORTANT SAFETY 3
- INSTRUCTIONS 3
- PRÉCAUTIONS D’INSTALLATION 4
- Getting started 5
- Features 6
- Accessories 6
- About this manual 6
- Cautions on handling 7
- Speakers 9
- Blu-ray Disc player and TV 10
- Power on 11
- Preparation 13
- Speaker Detection 13
- Measurement 13
- Calculation 14
- Parameter Check 15
- Error messages 15
- BD two times in a row 16
- Basic version 17
- Connections 18
- Connecting a TV 21
- Cables used for connections 22
- Supported iPod models 23
- Connecting a CD player 24
- Connecting an antenna 24
- n AM loop antenna assembly 25
- n Using the AM loop antenna 25
- Suspending on a wall 25
- Standing alone 25
- SPKR A/B 27
- Playing a CD player 28
- Playing a USB memory device 28
- n USB operation 29
- ON to turn on power to the 30
- NET/USB twice to switch 30
- ENTER, p or 1 30
- SATR twice to switch the 31
- TUNING + or TUNING – to 31
- 1, 2 and 3 32
- Tuning in radio stations 32
- n Parental Lock 33
- n SIRIUS operation 33
- n Selecting audio programs 33
- SHIFT/TOP MENU to select 34
- PRESET +, PRESET – or 34
- SEARCH/INFO 34
- STATUS while an HD Radio 34
- SURR. to select the 35
- P.DIRECT to select the 37
- SURR. to select “DOLBY 37
- Advanced version 38
- 5.1-channel connection 41
- Front A/B connection 41
- 2.1-channel connection 42
- Bi-Amp connection 42
- Set up speakers 43
- REMOTE CONTROL jacks 44
- RS-232C connector 45
- DC OUT (TRIGGER OUT) jacks 45
- Playback (Advanced operation) 46
- Sleep timer function 47
- Panel lock function 48
- Various memory functions 48
- Connection (ZONE2) 49
- Z2 to switch the remote 50
- ON to turn on the ZONE2 50
- INPUT df 50
- How to make detailed settings 51
- ENTER to register it 53
- Input Setup 54
- Auto Preset 55
- Antenna Aiming 56
- Preset Name 56
- Input Assign 56
- Playback Mode 59
- Audio/Video Adjust 60
- n Audyssey Settings 61
- Audyssey Dynamic EQ is 62
- n Manual EQ 63
- n M-DAX 63
- n Audio Delay 63
- Manual Setup 65
- MULTEQ is pressed 68
- Other settings 72
- Operating AV equipment 73
- Registering preset codes 74
- SET until indicator blinks 75
- SET and 76
- SOURCE SEL until the LEARN 76
- Operating macro function 78
- Setting the back light 79
- Information 80
- Part names and functions 81
- Rear panel 83
- Remote control unit 84
- Inserting the batteries 85
- Other information 86
- Surround 87
- Symbols in the table 89
- Explanation of terms 92
- Troubleshooting 94
- Resetting the microprocessor 96
- Specifications 97
- Blu-ray Disc Player 101
- DVD Player 101
- Satellite Receiver 101
- Television 101
- CD Player 102
- Unit : mm (in) 103
- D&M Holdings Inc 104
Related products and manuals for Receivers and Amplifiers Marantz SR6005
(15 pages)
(104 pages)
(104 pages)© 2020, manymanuals.com. All rights reserved. | 1.974 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals