Marantz SR6005 User Manual Page 61
- Page / 104
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
57
Basic versionSimple version Information
ENGLISHDEUTSCHFRANÇAISITALIANOESPAÑOLNEDERLANDSSVENSKA
Advanced version
Setting items Setting details
Height Gain
Control the front height
channel volume.
Low : Reduce the front height channel volume.
Mid : Front height channel sound is output with standard sound volume.
High : Increase the front height channel volume.
NOTE
“Height Gain” is displayed for the following settings.
• When “Amp Assign” (vpage61) is set to “Normal”.
• When the “Speaker Config.” – “F.Height” setting (vpage62) is set
other than to “None”.
• When surround mode is “PLgz” or the PLgz decoder is used.
Default
The “Surround Parameter”
settings are returned to the
default settings.
Yes : Reset to the defaults.
No : Do not reset to the defaults.
n Tone
Default settings are underlined.
Adjust the tonal quality of the sound.
Setting items Setting details
Tone Control
Set the tone control function
to ON and OFF.
ON : Allow tone adjustment (bass, treble).
OFF : Playback without tone adjustment.
“Tone Control” can be set when “Dynamic EQ” (vpage58) is set to
“OFF”.
NOTE
• “Tone Control” settings are not reflected to ZONE2.
• The tone cannot be adjusted in the direct mode.
Bass
Adjust low frequency range
(bass).
–6dB – +6dB
“Bass” can be set when “Tone Control” is set to “ON”.
Treble
Adjust high frequency range
(treble).
–6dB – +6dB
“Treble” can be set when “Tone Control” is set to “ON”.
Audio/Video Adjust
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
Confirm the setting Return to previous menu
n Audyssey Settings
Default settings are underlined.
Set MultEQ
®
, Dynamic EQ
®
and Dynamic Volume
®
. These can be selected after Audyssey
®
Auto
Setup has been performed. For additional information on Audyssey technology, please see page 88.
NOTE
If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup,
you may not be able to select Dynamic EQ/Dynamic Volume, and “Run Audyssey” may be displayed.
In this case, either perform Audyssey Auto Setup over again or perform “Restore” (vpage11) to return to
the settings after Audyssey Auto Setup was run.
Setting items Setting details
MultEQ
Select one equalizer from
three modes. MultEQ
corrects both time and
frequency response
problems in the listening
area based on Audyssey
Auto Setup calibration. We
recommend “Audyssey”.
MultEQ is the prerequisite
function for Dynamic EQ
and Dynamic Volume.
Audyssey : Optimize the frequency response of all speakers.
Audyssey Byp.L/R : Optimize frequency response of speakers except
front L and R speakers.
Audyssey Flat : Optimize frequency response of all speakers to flat
response.
Manual : Apply frequency response set with “Manual EQ” (vpage59).
OFF : Turn “MultEQ” equalizer off.
• “Audyssey”, “Audyssey Byp. L/R” and “Audyssey Flat” can be
selected after Audyssey Auto Setup has been performed. “Audyssey”
is automatically selected after performing Audyssey Auto Setup. When
“Audyssey”, “Audyssey Byp. L/R” or “Audyssey Flat” is selected,
illuminates.
• After running Audyssey Auto Setup, if the
Speaker Configuration, Distance, Channel
Level, and Crossover Frequency have changed
without increasing the number of speakers
measured, only
illuminates.
• Press MULTEQ on the remote control unit to
set this setting.
NOTE
• “MultEQ” and “Manual” cannot be selected when “EQ Customize” is
set to “Not Used” (vpage64).
• When using headphones, “MultEQ” is automatically set to “OFF”.
- AV Surround Receiver 1
- IMPORTANT SAFETY 3
- INSTRUCTIONS 3
- PRÉCAUTIONS D’INSTALLATION 4
- Getting started 5
- Features 6
- Accessories 6
- About this manual 6
- Cautions on handling 7
- Speakers 9
- Blu-ray Disc player and TV 10
- Power on 11
- Preparation 13
- Speaker Detection 13
- Measurement 13
- Calculation 14
- Parameter Check 15
- Error messages 15
- BD two times in a row 16
- Basic version 17
- Connections 18
- Connecting a TV 21
- Cables used for connections 22
- Supported iPod models 23
- Connecting a CD player 24
- Connecting an antenna 24
- n AM loop antenna assembly 25
- n Using the AM loop antenna 25
- Suspending on a wall 25
- Standing alone 25
- SPKR A/B 27
- Playing a CD player 28
- Playing a USB memory device 28
- n USB operation 29
- ON to turn on power to the 30
- NET/USB twice to switch 30
- ENTER, p or 1 30
- SATR twice to switch the 31
- TUNING + or TUNING – to 31
- 1, 2 and 3 32
- Tuning in radio stations 32
- n Parental Lock 33
- n SIRIUS operation 33
- n Selecting audio programs 33
- SHIFT/TOP MENU to select 34
- PRESET +, PRESET – or 34
- SEARCH/INFO 34
- STATUS while an HD Radio 34
- SURR. to select the 35
- P.DIRECT to select the 37
- SURR. to select “DOLBY 37
- Advanced version 38
- 5.1-channel connection 41
- Front A/B connection 41
- 2.1-channel connection 42
- Bi-Amp connection 42
- Set up speakers 43
- REMOTE CONTROL jacks 44
- RS-232C connector 45
- DC OUT (TRIGGER OUT) jacks 45
- Playback (Advanced operation) 46
- Sleep timer function 47
- Panel lock function 48
- Various memory functions 48
- Connection (ZONE2) 49
- Z2 to switch the remote 50
- ON to turn on the ZONE2 50
- INPUT df 50
- How to make detailed settings 51
- ENTER to register it 53
- Input Setup 54
- Auto Preset 55
- Antenna Aiming 56
- Preset Name 56
- Input Assign 56
- Playback Mode 59
- Audio/Video Adjust 60
- n Audyssey Settings 61
- Audyssey Dynamic EQ is 62
- n Manual EQ 63
- n M-DAX 63
- n Audio Delay 63
- Manual Setup 65
- MULTEQ is pressed 68
- Other settings 72
- Operating AV equipment 73
- Registering preset codes 74
- SET until indicator blinks 75
- SET and 76
- SOURCE SEL until the LEARN 76
- Operating macro function 78
- Setting the back light 79
- Information 80
- Part names and functions 81
- Rear panel 83
- Remote control unit 84
- Inserting the batteries 85
- Other information 86
- Surround 87
- Symbols in the table 89
- Explanation of terms 92
- Troubleshooting 94
- Resetting the microprocessor 96
- Specifications 97
- Blu-ray Disc Player 101
- DVD Player 101
- Satellite Receiver 101
- Television 101
- CD Player 102
- Unit : mm (in) 103
- D&M Holdings Inc 104
Related products and manuals for Receivers and Amplifiers Marantz SR6005
(15 pages)
(104 pages)
(104 pages)© 2020, manymanuals.com. All rights reserved. | 1.393 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals